Radon Testing
Testing is the only way to find out if you have a radon problem. Homeowners
can test their homes using inexpensive and easy to use test kits, or by hiring a
Certified Tester to measure the radon concentration in their home. When testing
for a real estate transaction, a Certified Tester should be used.
How Radon Is Measured
Radon levels are measured in picocuries ("pee-co-cure-ees") per liter of air,
often noted as pCi/L. This measurement describes how much radioactivity from
radon is in one liter of the air found in a home.
- The EPA Action Level
EPA and the U.S. Surgeon General
strongly recommend that you fix your home if you have 4 pCi/L or more of
radon in your home.
There is no known safe level of exposure to
radon since lung cancer can result from low exposures to radon. Exposure to
radon at the EPA Action Level of 4 pCi/L poses a significant health risk. EPA
based the 4 pCi/L Action Level on four factors: the health risk involved; the
effectiveness of available mitigation technologies; cost-effectiveness; and, the
goal set by Congress to reduce indoor radon levels to as close to the outdoor
level as possible. EPA's estimate of radon-related lung cancer deaths is based
on the population of the U.S. exposed to the national average indoor radon
concentration of 1.3 pCi/L over a lifetime. Existing mitigation technologies
allow the radon level in most homes to be reduced to 2 pCi/L or less most of the
time.
Additional EPA recommendation: To help minimize your future risk,
you should also seriously consider taking action to fix your home if your radon
level is between 2 pCi/L and 4 pCi/L.
How to Buy A Test Kit
Radon test kits can be purchased at most larger
hardāware stores, from a Certified Radon Service Provider, or online directly
from a laboratory/manufacturer.
The Radon Program's partner
laboratory is offering short term test kits for $14.95 to California
residents. Test kits can be purchased by clicking on the link
below. To prevent any problems with the processing of the order disable all
pop-up blockers on your computer prior to entering data on the order form.
When Should You Retest Your Home?
Even if your test result is below 4 pCi/L, you should consider retesting your
home every two to five years. CDPH also recommends retesting for the following reasons:
- Living patterns change: If you begin living in a lower level of your home,
such as a new den in the basement, you should retest your home on that level.
- If you finish or renovate an unfinished area, you should test your home
before starting the project and after the project is finished.
- Earthquakes, subsidence, and other natural ground shifts: A change in the
ground beneath or around your home can open passageways in the soil allowing
radon gas to enter your home.
- Foundation shifts: As a home grows older, the foundation can shift; cracks
and other openings can occur, allowing radon gas to enter the home.
- After mitigation: If your home has been mitigated for radon, you should test
again to make sure the radon mitigation system works. The system should be
tested 24 hours after the system has been installed. You should also retest your
home (in the winter heating months) every two years after a
mitigation to make sure the system is functioning properly.
Types of Tests
Short-term test: The quickest way to test is with a
short-term test. Short-term tests can be deployed between two days to 90 days,
depending on the type of device. Charcoal canister, electret ion chamber,
continuous monitor and charcoal liquid scintillation detectors are most commonly
used for short-term testing.
- If the average of the first and second short-term test is less than 4 pCi/L,
no action is needed, but if you tested during the summer months, you might
consider either a year-long test or another short-term test during the heating
season.
- If the average of the first and second short-term test is equal to or
greater than 4 pCi/L, we recommend fixing or mitigating your home.
In California, the best time to use a short-term test kit is in the colder
months, when radon levels typically tend to be naturally higher.
Long-term tests: Because radon levels tend to vary from day
to day and season to season, a long-term test will give a year-round average
radon level, whereas a short-term test can only tell you what your radon level
is during the 2 to 4 day period that you tested. Long-term tests are deployed
from 91 days to 12 months. Alpha track and electret detectors are commonly used
for this type of testing.
- Fix your home if your long-term test result is 4 pCi/L or more.
- If you have never tested your home, start with a short-term test kit. This
will determine whether the home has a severe radon problem. If you receive
results just under 4 pCi/L, you may want to follow up with a long-term test kit
to confirm your home's average radon concentration.
What do my Test Results Mean?
This charts shows the CDPH recommendations for
your test results:
Short Term | less than 2 pCi/L | Retest every few years or when conditions change | Retest every few years or when conditions change |
Short Term | 2-4 pCi/L | Consider retesting now, with a long or short-term test
kit | Consider fixing your home |
Short Term | 4-8 pCi/L | Retest Now with a long or short-term test kit | Fix the Home |
Short Term | greater than 8 pCi/L | Retest Now with a short-term test kit to confirm results | Fix the Home |
Long Term | less than 2 pCi/L | Retest every few years or when conditions change | Retest with a short-term test every few years or when conditions
change |
Long Term | 2-4 pCi/L | Consider fixing the home | Consider fixing the home |
Long Term | greater than 4 pCi/L | Fix the home | Fix the home |
āRadon Program āā